Battery switch
Power on/Power off
8.Riding Safety
Battery switch
1.Press to turn on the battery.
2.Press to turn off the battery.
19 20
Your e-bike is driven by a motor embedded in the hub of the rear wheel . The motor is powered by a battery. The amount of
power delivered to the motor is controlled by the power mode you choose.
Pedal-only Mode
If you don’t start the bike, you can ride it as a bike, no power assistance at all.
Throttle Mode
If you start the bike, you can push the throttle with your thumb to accelerate. The deeper you push, the faster you go. If you
let go of the throttle, the motor will stop.
Electric -Assisted:
You must turn on the battery&display to use the e-bike in Electric-Assisted mode.
In the Electric-Assisted model, power assist is triggered when you pedal forward, and power assist stops when you stop
pedaling. In other words, power assist happens as long as you pedal. You don’t need to pedal hard. All you need is to apply
a light force to the pedals continuously to maintain the current flow. When you apply one of the brakes, power-assist will
automatically stop. allowing the e-bike to slow down and stop. Power assist will turn itself off when the e-bike has reached
the maximum speed of 32km/h.
For your safety, please read this manual thoroughly before riding.Obey the traffic rules,don't exceed the speed
limit,don't run a red light,
don't go in the wrong direction. Wear a helmet and other gears to minimize the potential harm.
Power on:Turn on the battery,hold the power button for 1.5s,
the bike will power on.
Power off:Hold the power button on the display for 1.5s, the
bike will power off, turn off the battery.
To Next Page
Loading...
