Need help?Do you have a question about the Yaesu FT-8000R and is the answer not in the manual?
General| Brand | Yaesu |
|---|---|
| Model | FT-8000R |
| Category | Transceiver |
| Language | English |
Overview of the FT-8000R transceiver's features and capabilities.
Technical specifications for the FT-8000R, including frequency, power, and dimensions.
List of accessories included with the FT-8000R.
List of optional accessories available for purchase.
Details on VOL/SQL, TX/RX LED, and Main Dial.
Explanation of the primary and alternate functions of the function keys.
Description of specific command keys like PWR, VFO/MR, etc.
Information on the microphone connection and right-side controls.
Overview of the FT-8000R's Omni-Glow LCD display.
Explanation of the various icons and indicators shown on the LCD.
Details on connecting the antenna and TNC via the DATA jack.
Information on DC power input and external speaker outputs.
Description of the PTT, DTMF LED, and function keys on the MH-36 microphone.
Description of the [ACC] and DTMF keys on the MH-42B6J microphone.
Steps for inspecting the transceiver upon receipt.
Advice for proper installation, including ventilation.
Important safety guidelines for operating the transceiver.
Guidelines for selecting and connecting antennas.
Information on coaxial cable types and loss figures.
Instructions for mounting the transceiver in a vehicle.
How to connect power and external speakers in a mobile setup.
Setting up for base station use with AC power and TNC.
Detailed pinout for the data jack used with TNCs.
Using the PC software for transceiver configuration.
Initial steps before operating the transceiver for the first time.
How to turn the unit on and view the DC supply voltage.
How to set audio levels and squelch for each band.
Understanding the display and switching between VHF/UHF bands.
Features for band identification and keypad feedback.
How to adjust the LCD screen's brightness.
Methods for selecting frequencies using the VFO mode.
Setting channel steps and enabling VFO tracking.
How to temporarily reduce audio levels from the receivers.
Procedures for disabling one band for monoband use.
Operating in VHF-VHF or UHF-UHF modes.
Controlling the sub band without affecting the main band.
How to transmit and adjust RF power output levels.
Setting up standard and non-standard repeater frequency offsets.
How ARS automatically selects repeater shifts.
Defined subbands for automatic repeater shift activation.
Storing independent transmit and receive frequencies.
Detailed steps for storing frequencies and settings into memory.
How to access and operate using stored memories.
Feature to step through memories on both VHF and UHF bands.
Setting up and using one-touch home channel frequencies.
Adjusting stored memory settings like frequency and shift.
Temporarily hiding or unhiding memories.
How to start, stop, and control band and memory scanning.
Selecting how the scanner behaves after detecting a signal.
Skipping specific memories during scan operations.
Setting custom lower and upper limits for scanning.
Automatically finds and loads active frequencies into memory.
Automatically checks a designated memory for activity.
Setting and activating CTCSS tones for repeater access.
Using the FTS-22 for audible alerts on CTCSS calls.
Storing and sending telephone numbers via DTMF.
Pinout and usage details for the rear panel data jack.
Procedure for configuring the FT-8000R as a cross-band repeater.
Using the radio as a range extender for hand-helds.
How to enable, disable, or reset settings using power-on key combinations.
Common issues and how to resolve them.
Procedure to restore factory defaults by resetting the CPU.
Information about the internal backup battery and its replacement.
To Next Page
