Yaesu FTM-400 User Manual

V1.0 22/07/2019 KB
Configure the Yaesu FTM-400 for GB7MT
Technical
Information
Yaesu UK Limited
Unit 12 Sun Valley Business Park, Winnall Close, Winchester, Hampshire, SO23 0LB
1) Please make sure that your callsign has been entered in your radio. If not, please refer the Operator Manual.
2) Enter the output frequency of GB7MT 439.6625MHz
Make sure the radio is in VFO mode
.
Touch to toggle between VFO and
Memory mode.
Press
The function menu will be displayed.
Touch
The number input screen will be displayed.

Yaesu FTM-400 Specifications

General

Modes	FM, C4FM
Memory Channels	1000
Antenna Impedance	50 Ohms
Digital Modes	C4FM
Voltage	13.8 VDC
APRS	Yes
Display	Full-color TFT LCD
GPS	Built-in
Weight	1.2 kg
Bluetooth	Optional (with BU-2 Unit)
Output Power	50 / 25 / 5 Watts
Dimensions	140 x 40 x 180 mm

Summary

Enter Output Frequency

Set VFO Mode

Ensure the radio is in VFO mode by toggling the V/M button.

Input Frequency via Number Screen

Access the number input screen to enter the frequency.

Set Mode to C4FM

Enable Automatic Mode Switching

Activate AMS mode for automatic switching between DN, VW, or FM.

Setup Repeater Shift Frequency

Access Setup Menu

Press and hold the SET button to display the Setup Menu.

Configure Shift Frequency

Select and set the repeater shift frequency to 9.00 MHz.

Store Repeater Frequencies

Access Memory Writing Screen

Press the F button to display the memory writing screen.

Select Memory Channel

Turn the DIAL to select the desired memory channel.

Save Data to Memory

Press the F button to save the frequency and memory channel number.