1033380C-1/15
CARRIER (2x)
IMPORTANT WARNING: IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY
ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD
CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS
AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE
PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE
INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO
NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND
ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED
BY A PROFESSIONAL INSTALLER SUCH AS A QUALIFIED GARAGE OR AUTO BODY SHOP.
Part #1033380 Rev.C
Base Screw (4x)
SKIS AND BOARDS UNDER
170 cm:
Crossbars must be spread
between 12" and 24"
SKIS AND BOARDS OVER
170 cm:
Crossbars must be spread
between 12" and 36"
(MOUNTING BRACKET PARTS:)
Slider Top (4x)
Bail Screw (8x)
installed
Upper Bail (4x)
Pad (4x)
Square Nut (4x)
Lower Bail (4x)
Hex Wrench (1x)
Long Bail Screw (8x)
for some
larger factory bars
YAKIMA Q TOWERS: DO NOT REPOSITION YOUR TOWERS!
Vinyl Pad Sheets (2x)
for factory bars
UNIVERSAL
MOUNTING
BRACKET
(4x)
CROSSBAR SPREAD
To Next Page
Need help?
General
