Yakima BowDown User Manual

INSTRUCTION #1033423E-1/21
IMPORTANT WARNING! IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY
ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD
CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS
AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING
THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF
THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT
UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER.
BOWDOWN (2X)
HEAVY DUTY STRAP (2X)
MINIMUM CROSSBAR SPREAD 24” (61CM)
Steel Hook (2X)
Plain Strap (2X)
Plastic Tube (2X)
Buckle Strap (2X)
SHORT BLACK
T-BOLT (2X)
BOW STERN TIE DOWN
FOR FACTORY RACKS: Check fitlist notes,
or Yakima.com for your vehicle’s crossbar spread.
RECOMMENDED ACCESSORY:
Hood Anchor
Yakima Part #8007416
Hood Anchor creates a
secure attachment
point at your hatch,
trunk or hood for bow
and stern tie downs.

Yakima BowDown Specifications

General

Category	Automobile Accessories
Type	Kayak Carrier
Capacity	1 kayak
Weight Capacity	80 lbs
Mounting Style	Roof rack
Foldable	Yes
Color	Black
Compatibility	Most roof racks
Material	Steel

Summary

Product Overview and Safety

Important Safety Warning

Critical information regarding secure attachment and potential risks of improper installation, leading to accidents or injury.

Prepare for Installation

Adjust Bail Position

Install Bowdown on Vehicle

Position Bowdown

Set Bowdown to Vertical

Secure Bowdown to Crossbar

Closing the bail around the crossbar and tightening the unit securely.

Install Second Bowdown

Load Boat and Tie Down

Pass and Loop Strap

Load Boat and Secure Straps

Bringing straps over the boat, hanging them, and ensuring proper routing.

Continue Tie Down and Lock Installation

Connect and Tighten Straps

Inserting strap end into buckle and tightening securely, managing excess strap.

Install SKS Locks

Bow Stern Tie Down Attachment

Adjust Strap Tension

Before Driving Away and Weight Limits

Pre-Drive Checks

Testing movement, tightening knobs, and reviewing all cautions.

Weight Limits

Understanding the total weight capacity for the rack, product, and load.