Yakima FrontLoader User Manual

CROSSBAR SPREAD
1033644B-1/18
IMPORTANT WARNING
IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER
ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR
TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS
PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND
UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU
DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER.
Part #1033644 Rev.B
FRONTLOADER (1X)
*CROSSBAR SPREAD
Your crossbar
spread is
the distance
between the
crossbars.
If you have factory crossbars, be sure you have
at least 1-1/2” (3.8 cm) of clearance between
the bottom of the crossbar and the vehicle roof.
16" - 18”
41cm - 46cm
18" - 48"
46cm - 122cm
Weight Limit
30 lbs. (13.6kg)/bike
40 lbs. (18.1kg)/bike
Crossbar Spread
DO NOT EXCEED RACK WEIGHT LIMITS!
DO NOT EXCEED RACK WEIGHT LIMITS!
2x
max.

Yakima FrontLoader Specifications

General

Bike Capacity	1 bike
Max Bike Weight	40 lbs
Tire Width Compatibility	Up to 3"
Weight	13 lbs
Maximum Wheelbase	48"
Maximum Crossbar Spread	48"
Load Capacity	40 lbs
Number of Bikes	1
Type	Roof Rack
Bike Mounting	Front
Wheel Size Compatibility	20" to 29"
Lockable	Yes
Fits	Most factory and aftermarket crossbars
Material	Steel
Mounting Type	Roof
Locking Mechanism	Sold separately

Summary

Critical Safety Warnings

Step 1: Mounting FrontLoader onto Crossbars

Step 2: Tightening Clamps

Securing Rear Clamp

Closing and tightening the rear clamp around the rear crossbar.

Securing Front Clamp

Turning the front knob clockwise to fully tighten the front clamp.

Step 3: Wheel Setting

Matching Wheel Size

Sliding the wheel grip to match the visible wheel size and adjusting grip height.

Closing Red Levers

Step 4: Load Bike

Aligning Front Wheel

Securing Wheel Hoop

Step 5: Secure Rear Wheel

Threading Strap

Inserting Strap End

Tightening Strap

Step 6: Lock Your Bike

Securing Bike Frame

Pre-Drive Checks

Checking Front Wheel Attachment

Ensuring the front wheel is securely attached to the bicycle frame.

Checking Knob Tightness

Periodically checking that all knobs are adequately tightened.

Checking Front Wheel Security

Verifying that the front wheel is secure.

Final Checks and Warnings

Tire Pressure Check

Hardware Tightness

Warning to ensure all hardware is secured and to check/tighten if necessary.

Weight Limits and Instructions

Understanding Weight Limits

Following Yakima Fit List for rack weight limit and not exceeding vehicle's rack limit.