Yakima BowDown - Prepare for Installation; Adjust Bail Position; Install Bowdown on Vehicle; Position Bowdown

1033423E-2/21
Raise BowDown up,
then tighten the knob
with firm pressure.
PREPARE FOR INSTALLATION
Loosen the knob 6
to 8 turns. Do not
remove knob.
ROUND BAR
Middle notch
for round bars.
Position the tip of BowDown so that it
protrudes slightly further than the crossbars.
FACTORY
BAR
ONLY
ADJUST BAIL POSITION (IF NECESSARY)
POSITION BOWDOWN ON VEHICLE
Choose best
position for most
secure grip.
Position BowDown
on the crossbar.
NOTE: Some smaller
factory bars may require
the short, black T-bolts
included with this product.
INSTALL BOWDOWN
Upper notch for
square bars.
SQUARE BAR