Yakima LANDING PAD 22 User Manual

INSTRUCTION #1035907B-1/12
LANDING PAD 22
BASE COVERS
BASE (4X)
FLAT PAD (4X)
STEPPED PAD (4X)
Refer to YAKIMA SkyLine or Control Tower instructions for important
warning and load limitations, and YAKIMA’s limited warranty.
1RWH&URVVEDUVSUHDGLV¿[HG
INCLUDED TOOL:
5 mm hex wrench
M8 HARDWARE BAGM6 HARDWARE BAG
Metal Washers (4X)
Metal Washers (4X)
M6 X 28mm (4X)
M6 X 33mm (4X)
Landing Pad 22
with stepped pad
Landing Pad 22
with flat pad
M8 X 35mm (4X)
HARDWARE BAG CONTENTS
(4X)
M6 X 40mm (4X)

Yakima LANDING PAD 22 Specifications

General

Brand	Yakima
Model	LANDING PAD 22
Category	Racks & Stands
Language	English

Summary

Hardware Bag Contents

M6 Hardware Bag

Contains M6 screws and washers for installation.

M8 Hardware Bag

Contains M8 screws and washers for installation.

Included Tool

Specifies the 5 mm hex wrench provided for installation.

Base Covers

Components to cover the base of the landing pads.

Installation Steps

Clean Vehicle Roof

Thoroughly clean the vehicle's roof before proceeding with installation.

Open Cover Plates

Instructions on how to open vehicle cover plates.

Prepare Threads

Ensure roof mounting threads are clear of debris and paint.

Install Pads to Bases

Attach the landing pad to its corresponding base.

Attach Landing Pads

Secure landing pads to vehicle roof using specific hardware and wrench.

Adjust and Tighten Landing Pads

Position, adjust, and finally tighten landing pads with towers installed.

Install Covers

Install base covers when the rack is not attached.

Read Warnings

Important safety information, load limits, and maintenance advice.

Continue Tower Installation

Proceed with the installation of SkyLine or Control Tower components.