To Next PageTo Next Page
Need help?Do you have a question about the Yakima showdown and is the answer not in the manual?
General| Brand | Yakima |
|---|---|
| Model | showdown |
| Category | Automobile Accessories |
| Language | English |
Apply felt pads to the saddles before mounting.
Ensure all four mounting clamps are completely open.
Position the left and right ShowDown units correctly on crossbars.
Securely tighten all mounting clamps.
Verify the installation is secure and re-tighten if necessary.
Fold in side mirrors before loading or unloading boat/SUP.
Release the safety pin from the loader mechanism.
Extend the loader fully and lower it gently.
Adjust inboard cradles and pull down support hoops.
Remove all safety pins before unloading.
Lower the ShowDown carefully using the handles.
Detach and remove all securing straps.
Safely lift the boat from the carrier.
Fold the support hoops upwards.
Loosen saddle knobs and slide them against support hoops.
Tighten saddle knobs to ensure full contact with the boat.
Raise the ShowDown using the handles.
Reinsert safety pins after unloading.
Remove the original inboard saddles.
Detach knobs and t-bolts from the removed saddles.
Install new SUP saddles and tighten them.
Review SUP specific guidelines before proceeding.
Loosen the clamp knobs to release the unit.
Safely detach the ShowDown from the vehicle.
Store the ShowDown securely when not in use.
