Yakima Swing Daddy 4 User Manual

1033439G-1/15
BASE (1X)
SAFETY CLIP (1X)
WASHER (1X)
WHEEL
STRAP (12X)
HITCH LOCK (1X)
SWING BOLT (1X)
WASHER (1X)
WASHER (1X)
HEX NUT (1X)
HITCH BOLT (1X)
LOCK WASHER (1X)
For Your
Safety
Warranty
Registration
on-line
YAKIMA.com
IMPORTANT WARNING
It Is crItIcal that all yakIma racks and accessorIes be properly and securely attached to your vehIcle. Improper attachment could
result In an automobIle accIdent, and could cause serIous bodIly Injury or death to you or to others. you are responsIble for
securIng the racks and accessorIes to your car, checkIng the attachments prIor to use, and perIodIcally InspectIng the products
for adjustment, wear, and damage. therefore, you must read and understand all of the InstructIons and cautIons supplIed wIth
your yakIma product prIor to InstallatIon or use. If you do not understand all of the InstructIons and cautIons, or If you have no
mechanIcal experIence and are not thoroughly famIlIar wIth the InstallatIon procedures, you should have the product Installed by a
professIonal Installer such as a qualIfIed garage or auto body shop.
Part #1033439 Rev.G
Do not use with a
hitch extender.
For use with 2"
hitch only.
PURCHASE SEPARATELY:
HITCHSKI
Carries up to 6 pr. skis or 4
snow boards.
Part #8002418
See at www.yakima.com
TOOLS REQUIRED:
ADJUSTABLE WRENCH

Yakima Swing Daddy 4 Specifications

General

Type	Hitch-mounted bike rack
Capacity	4 bikes
Material	Steel
Swing Away Feature	Yes
Warranty	Limited lifetime warranty
Hitch Size	2-inch receiver
Compatibility	Fits 2" hitch receivers only
Locking Mechanism	Integrated cable locks for bikes, hitch lock included
Foldable	Yes
Installation	Tool-free installation

Summary

Important Safety Warnings

Installation and Initial Setup

Insert Tongue into Vehicle's Hitch

Align receiver holes with base holes for initial hitch connection.

Install Hitch Bolt, Lock-Washer, and Washer

Secure the hitch receiver to the base using the provided hardware.

Install Safety Pin or Lock Tongue

Secure the hitch connection with a safety pin or lock for stability.

Position Mast and Secure Assembly

Lift and align the mast, then tighten the wing bolt to secure the mast to the tongue assembly.

Loading and Securing Bikes

Extend and Position Carrier Arms

Extend the carrier arms and attach rubber straps to cradles and stabilizers.

Cradle Positioning and Bike Loading

Position cradles, load the heaviest bike first, and stabilize bike frames.

Secure Bikes with Straps

Pull straps tightly over bike frames, ensuring they are hooked securely.

Securing Bikes and Accessing Vehicle Rear

Lock Bikes to Carrier

Secure bikes to the carrier using the integrated lock cable.

Accessing Vehicle Rear

Steps to retract the mast and swing the carrier away from the vehicle.

Pre-Drive Safety Checks

Ensure the gate is closed, wing bolt tightened, and perform safety checks before driving.

Operation and Maintenance

Perform Safety Checks

Verify wing bolt tightness, strap security, and hardware for safe operation.

Lowering the Arms

Unload bikes, lift arm latch, pull lever, and lower arms completely.

Important Load Limits and Usage Restrictions

Adhere to weight limits and avoid off-road use or specific bike types.

Maintenance and Technical Support

Use appropriate lubricants, cleaning methods, and contact support for assistance.