1030988F-3/9
Center
punch, pilot,
drill, clear,
seal, install
Plusnuts®
(Steps 5
through 11).
Apply a generous
amount of silicone
sealant into the
Plusnut® opening.
Slide nut plates from your tower kit into
track (2 per tower / 4 per track).
With track on car, attach bolts and hard
washers through track into Plusnuts®.
Do not use
washers
on bolts at
each end of
tracks.
Congratulations!
Install your towers
& mount your
accessories for your
next sporting
adventure!
THIS PRODUCT IS COVERED BY YAKIMA’S
“LOVE IT TILL YOU LEAVE IT” LIMITED LIFETIME WARRANTY
TO OBTAIN A COPY OF THIS WARRANTY, GO ONLINE TO
WWW.YAKIMA.COM OR EMAIL US AT YAKWARRANTY@
YAKIMA.COM, OR CALL (888) 925-4621
You should plan to use every other
hole if you can. DO NOT skip more
than two holes in a row!
Mark the remaining holes for each track.
Loosen bolts and remove
track from vehicle.
KEEP THESE INSTRUCTIONS!
WARNING: Direct contact of uncured sealant irritates eyes and may irritate
skin. Over exposure to vapor may irritate eyes, nose and throat. Avoid eye and
skin contact. Use with adequate ventilation. Do not handle contact lenses with
sealant on hands. In case of eye contact, flush with water for 15 minutes. Obtain
medical attention. In case of skin contact, remove from skin and flush with water.
Sealant releases acetic acid (vinegar-like odor) during cure.
Attach end caps before attaching tracks to roof.
NOTE: There may be extra Plusnuts® because
not all holes in the tracks will be used.
To Next Page
Loading...
