An ASSA ABLOY Group brand
80-9470-0724-000 (02-13)
Exit Device Shim Kits
Installation Instructions
Shim Locations
#724, 724WS, 724NS, and 224 Shim Kits for
Surface Vertical Rod Exit Devices
Vertical Latch Shim
60-7010-1060-200
Rod Guide Shim
60-7010-1065-200
Device Shim
Standard
60-7100-1004-200
2100/1800 and
Narrow Stile
60-7000-1106-200
Device Shim
Standard
60-7100-1004-200
2100/1800 and
Narrow Stile
60-7000-1106-200
Device End Cap Shim
7000 Series - 60-7000-1107-200
2100/1800 Series - 60-2000-1181-200
Device End Cap Shim
7000 Series - 60-7000-1107-200
2100/1800 Series - 60-2000-1181-200
#723, 723WS, 723NS, 723NSWS, and 223 Shim Kits
for Rim, Mortise, & CVR Exit Devices
Note: Use shim in addition
to the Latch Mounting Plate.
Top and Bottom.
Notes:
1. Each standard shim kit contains 2 sets of
1/8" thick shims. Windstorm (WS) shim kits
contain 3 sets of 1/8" thick shims.
2. Place shims, as required. Use (1) shim
for each 1/8" (3mm) of device lift needed.
When mounting the device, position shims
as shown, using the installation instructions
packed with the unit. Use longer screws
provided.
3. For Concealed Vertical Rod Device
see yoke pin shim location per illustration
on page 2.
1
2
Attention Installer
Any retrofit or other field modification to a fire rated opening can
potentially impact the fire rating of the opening, and Yale Locks &
Hardware makes no representations or warranties concerning
what such impact may be in any specific situation. When
retrofitting any portion of an existing fire rated opening, or
specifying and installing a new fire-rated opening, please consult
with a code specialist or local code official (Authority Having
Jurisdiction) to ensure compliance with all applicable codes and
ratings.
To Next Page
Need help?
General
