Yale ENA-PIR

Wirefree Yale ENA-PIR
Passive infrared motion
detector
Features:
1. Test/Learn Button
To enter Test mode: Press once in Standby mode.
The LED will light up for two seconds whenever a
movement is detected.
2. Red LED Indicator
3. Knockouts for Wall / Corner Mounting
4. Supervision Enable / Disable Jumper
5. Movement High/Low Sensitivity jumper
6. Tamper Switch with spring
7. 3x 1.5V AA Alkaline Battery
8. Tilt Switch (protect against unauthorized EIR
removal, sabotage, or loose installation)
9. Top & Bottom Cover securing screw hole
Pack content:
1 x PIR
4 x Screws
4 x Wall Plugs
Supervision Enable/Disable Jumper
After installation, the PIR will automatically transmit
Supervisory signals periodically to the Control Panel
at random intervals of less than 20 minutes. If the
Control Panel has not received the signal from the
PIR for the preset period of time, the Control Panel
will indicate on its display that the particular PIR is
experiencing an out-of-signal problem.
Jumper On= Supervision Disabled
Jumper O= Supervision Enabled (Default)
Movement High/Low Sensitivity Jumper
Jumper On= Increase PIR sensitivity to movement
Jumper O= Decrease sensitivity (Factory Default)
SmartHome Alarm series
2
1
3
7
8
4
5
6
9

Yale ENA-PIR Specifications

General

Detection Range	Up to 12 meters
Wireless Frequency	868MHz
Operating Temperature	-10°C to +40°C
Type	PIR Sensor
Power Source	Battery
Power Supply	Battery
Compatibility	Yale Smart Home Systems

Summary

Product Features and Configuration

TestLearn Button

Button to enter Test mode; LED lights up on movement detection.

Power Supply

Jumper Settings

Supervision EnableDisable Jumper

Controls automatic supervisory signal transmission to the Control Panel.

Movement Sensitivity Jumper

Jumper to adjust PIR sensitivity to movement.

Programming and Installation

Programming Steps

Sequence for logging into engineer menu and learning the PIR.

Walk Test

Procedure to find the best installation location using signal strength.

Mounting Guidelines

Operation Modes

Sleep Timer

Tilt SwitchesTamper Spring

Activation conditions for tamper alerts based on device orientation.