Fixing Slots X 2
Keypad
Cradle Open
1 Drill holes into the wall using the fixing slots as a
template.
2 Fit wall plugs into the wall and fix cradle with the
screws provided.
3 Slide the keypad into the cradle
4 Close the cradle cover so the logo is facing you
Mounting the PIR
1 Find a location where the PIR is to be mounted. It
should be mounted high up, either on at surface
or in a corner. See section “Location planning” for
suggestions.
2 Perform a radio range test by pressing Test/Learn
Button on the PIR and the siren will beep once.
This indicates the device is within range. If this
step fails, find an alternative location to place the
PIR nearer to the siren.
3 Open the PIR by loosening the bottom screw.
Corner fixing
knockouts X 4
Wall fixing
knockouts X 2
4 Knock out the relevant holes on the base where
the plastic is thinner. The center two knockout
holes are for at wall mounting while the 4 side
holes are for corner mounting.
5 Drill holes into the wall using the knockout holes on
the base as a template.
6 Fit wall plugs and secure the PIR base with the
screws provided.
7 Fit the PIR back together and tighten bottom
screw, the PIR installation is complete.
*The PIRs have a built-in sleep timer to save
battery power. If there is no movement in front
of the PIRs for 1 minute, the PIRs will become
‘ready to signal’ and movement will now be
reported. The PIRs will sleep for 1 minute after
reporting.
Any movement detected in sleep time will not be
reported and will extend the sleep period by a
further 1 minute.
Mounting the door/window contact
Frame
Door/Window
Gap no more
than 8mm
Magnet
Sensor
1 Find a location where the door/window contact
is to be mounted. It should be mounted between
the door/window frame and the door/window as
shown at the top of the opening. The magnet is to
go on the door/window while the sensor is to be
placed on the frame. The gap between the magnet
and sensor should be no more than 8mm when
closed. Windows can be protected in a similar way
to doors. Make sure the tamper switch spring is
fully depressed.
To Next Page
Loading...
