EasyManua.ls Logo

Yale HSA6200

Yale HSA6200
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Adding devices for the first time
See section 3 for adding extra devices in preparation
for first time system installation.
Adding devices to an already installed
system
The installed system will be controlled by either a
keyfob(s) or a keypad(s).
Keypad
1 Press button “A” followed by the user PIN code
to enter test mode indicated by a continuously
ashing LED.
2 Press button “A” followed by “2” to switch off the
system tamper while installing the new device, the
siren will beep in response.
3 Press button “A” followed by “4” to put siren
into learn mode, the siren will beep and ash in
response.
4 Press device learn/test buttons (see section 3,
step 2 onwards) to trigger learning-in signals, the
siren will beep and ash when each device is learnt
in.
5 When all the devices have been learnt in, press
button “A” and “5” to quit learn mode.
• Learn-in mode will automatically time out after 3
minutes.
6 When installation is nished press button “A” and
“3” to rearm tamper protection.
• Tamper protection will automatically rearm after 1
hour.
7 Press Disarm twice to exit.
Keyfob
1 Press the Arm and Home buttons together and
continuously for 5 seconds until the LED stops
ashing, to switch off the tamper while installing
the new device. The siren will beep in response.
2 Press the Home and Emergency buttons together
and continuously for 5 seconds until the LED stops
ashing, the siren will beep and ash in response.
3 Press device learn/test buttons (see section 3,
part 2) to trigger learning-in signals, the siren will
beep and ash when each device is learnt in.
4 When all the devices have been learnt in press and
hold the Disarm button to quit learn mode.
• Learning in mode will automatically time out after 3
minutes.
5 Press the Arm and Emergency buttons together
and continuously for 5 seconds until the LED stops
ashing to rearm tamper protection.
• Tamper protection will automatically rearm after 1
hour.
Adding accessories
To provide additional protection you can add extra door/window contacts, PIRs, keyfob
remote controls, keypad remote controls, help buttons and smoke detectors. These are
available separately from your local stockist.

Other manuals for Yale HSA6200

Related product manuals