11
Setting up devices
•
Adding new devices (Optional: Use it only if you have extra devices outside the kit)
All devices in the kit are linked to the Smart Hub. If you want to add more devices, you can do this by using the “Add new device”
section in the Smart Living Home app.
Exit Learn Mode:
Press Stop learning mode on the app
3
Go to the app menu
Setting > Alarm Setting > Devices and then press Add New Device button
1
Enter Learn Mode
Learn/ Test
button
Press & hold
for 3 seconds
Learn/Test
button
One single
press.
For the following accessories, please hold the Learn button for 10 seconds, before releasing to enter Learn mode.
Learn/Test
button
One single
press.
Learn/Test button
One single press.
Hold for 3 seconds
Hold for 3 seconds
Hold for 3 seconds
Learn/Test button
One single press.
Learn/Test
button
One single
press.
Learn/Test
button
Press 8 and 9
together
Learn/Test button
Learn/Test button
Learn/Test button
LED
Press the learn button on the device you leant to add then see diagrams below. The Smart Hub will beep (single or multiple
dependent on device) when a new device is registered. You will then see your new device in your device List within the home app.
2
If the accessory doesn’t learn in, remove the batteries for 5 seconds, then replace
and try relearning within 3 minutes.
EF-PETPIR
SR-PC
SR-PVC
SR-PS
Learn in Devices
Ensure you
initialise your
keypad before
you learn it in.
(See page 17)
SR-PVC must be learned in with the
tamper screw removed so that the tamper
is open. Sensor will not learn with tamper
closed.
To Next Page
Loading...
Need help?
General
