20 21
》 To Release Safe Handle Setting
Open the battery cover and
take out a hex wrench.
Keep pressing the Safe Handle button.
Turn the set bolt found in next to
the handle to Close side.
》 To Set Safe Handle
Open the battery cover and
take out a hex wrench.
Turn the set bolt found in next to the
handle to Open side until the Safe Handle
button comes out.
Volume Setting Feature
It enables you adjust the volume of various sounds from the product.
》 Volume Setting
To set volume switch
Order Play Description
Settings
Safe Handle Feature
The technology to prevent a forced attempt to drill a hole in the door and unlock the Doorlock has been applied. Auto Lock setting locks a door within 5 seconds after the door was closed.
The default setting is Normal Mode.
Settings
Change to Fingerprint Mode
Press number 1 and 1 button
➞
Enter the Master Number
》 Fingerprint Mode Setting
Order Play Description
Ⓘ
Press number 1 and 3 button
➞
Enter the Master Number
Press (Registration)
button and button
Ⓘ
》 To Set Auto/Manual Feature
Auto Lock Setting
Manual Lock Setting
Order Play Description
Auto / Manual Feature
Security Mode Setting
Normal Mode Setting
Directions
•
Be careful that the set bolt won’t detach when modifying the Safe Handle Setting.
•
Even when the operation sound is set as ‘Mute,’the error and alarm sounds will go off.
Note
•Even after a door was locked by the Auto Lock function, please check again if the door was completely locked.
•It is advised to keep the fingerprint exclusive number(4 digits) as a separate list just in case for a separate
fingerprint deletion at Security Mode.
•If more than 1 fingerprint is registered after the Security Mode is set, you may not open a door with a password.
(If the fingerprint module is broken, you may use a password.)
Note
Press (Registration)
button
To Next Page
Loading...
