What to do if Yamaha 50HET Outboard Motor fuel management gauge shows incorrect fuel consumption?
If the fuel management gauge shows incorrect fuel consumption, the engine recognition might be wrong (especially for multi-applications). To fix this, default the engine number and turn the key switch on in order from the portside engine to re-memorize each engine number.
Why Yamaha Outboard Motor gauge operates unstably?
If the gauge operates unstably, it could be because a resistor is not connected to the ending hubs. Connect the gray 6-pin cap to the ending multi-hubs.
How to fix Yamaha 50HET trim gauge showing incorrect position?
If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sender could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sender.
Why Yamaha 50HET Outboard Motor Speedometer or Comb. Speedometer & Fuel mgt gauge shows incorrect fuel level?
If the speedometer or combination speedometer & fuel management gauge shows an incorrect fuel level, the fuel sensor selection is likely wrong. Set up the fuel sensor to the correct resistance.
What to do if Yamaha Outboard Motor gauge shows “----”?
If the gauge displays '----', it indicates that the digital signal is not being received. Check that the couplers are securely connected and replace any damaged bus wires or hubs.
What causes Yamaha 50HET fuel management gauge to show incorrect remaining fuel?
If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting may be wrong (specifically for SQR Fuel mgt Gauge). Fill the tank with fuel, and set the correct fuel tank capacity.
How to fix Yamaha 50HET tachometer showing incorrect engine RPM?
If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong (especially for multi-applications). To correct this, push the 'SET' button for 10 seconds to default the engine number, then memorize each engine number again.
Why Yamaha 50HET illumination does not light?
If the illumination does not light, it could be due to a lack of electrical power or a damaged gauge. You should try replacing the fuse, connecting the couplers securely, replacing the damaged wire or hub, or replacing the gauge.
What to do if the Yamaha 50HET Outboard Motor gauge display does not wake up?
If the gauge display doesn't wake up, it could be due to a lack of electrical power or a damaged gauge. Try these steps: replace the fuse, securely connect the couplers, replace any damaged wires or hubs, or, if necessary, replace the gauge itself.
General| Brand | Yamaha |
|---|---|
| Model | 50HET |
| Category | Outboard Motor |
| Language | English |
Indicates a hazardous situation that could result in death or serious injury if not avoided.
Details the step-by-step process for safely removing the outboard motor from its shipping crate.
Provides guidance on correctly positioning the outboard motor on the boat transom for optimal performance.
Guides users on how to choose the most suitable propeller based on boat type and operating load.
Introduces the multi-function tiller handle and its electrical functions, compatible engines, and included components.
Illustrates the electrical connections for the 6X4 multi-function tiller handle for US models.
Provides procedures for securely installing gauges to electrical start models, considering panel clearance and angles.
Explains the function and applications of the analog tachometer for monitoring engine speed and setting throttles.
Describes the digital tachometer's functions, including hour meter, trim meter, and oil warning indicator.
Details the speedometer's function, types, and applications, including calibration for different units.
Explains the functions of the fuel management gauge, including fuel flow, consumption, and economy.
Shows representative wiring diagram samples for Yamaha remote controls and instruments.
Illustrates wiring diagrams for single and dual station applications with 6Y9 gauges.
Provides guidance on selecting suitable batteries based on engine model, capacity, and charging voltage.
Explains wiring procedures for single and multi-engine installations, including isolator-equipped models.
To Next Page
