What to do if Yamaha Outboard Motor trim gauge always shows fully tilted up position?
If the trim gauge always shows a fully tilted-up position, the trim sender signal is not being received. Connect the pink lead connectors to each other.
Why Yamaha Outboard Motor boat speed and/or coolant pressure gauge does not show?
If the boat speed and/or coolant pressure gauge does not show, it is likely that the optional sensor has not been installed. Install the optional sensor.
General| Brand | Yamaha |
|---|---|
| Model | 55BET 55DEHD E60HMHD |
| Category | Outboard Motor |
| Language | English |
Instructions to avoid severe injury or death.
Precautions to avoid damage to the product.
Step-by-step guide for safely uncrating the outboard motor from its steel frame.
Procedures for correctly mounting the outboard motor onto the boat transom.
Guidance on selecting the correct propeller pitch for varying load conditions and engine speeds.
Describes the electrical functions and components of the 6x4 multi-function tiller handle.
Covers fuel management gauge functions, applications, dimensions, and setup procedures.
Wiring diagrams for single, twin, and triple engine setups with digital network gauges.
Steps for initial setup of digital network gauges, especially for multi-engine installations.
Common troubleshooting tips for issues with digital network gauges and system setup.
Table listing suitable batteries based on model, unit, and minimum rating (CCA, MCA, RC, etc.).
Wiring instructions for isolator-equipped models and twin-battery configurations.
Checklist for static and dynamic checks to ensure customer satisfaction before delivery.
To Next Page
