EMF00010
Chapter 3
OPERATION
INSTALLATION ........................................3-1
Mounting the outboard motor ............3-2
Clamping the outboard motor.............3-4
FILLING FUEL AND ENGINE OIL............3-5
Filling fuel ..............................................3-5
Gasoline and oil mixing .......................3-5
PRE-OPERATION CHECK ........................3-7
BREAKING IN (RUNNING IN) ENGINE ..3-8
STARTING ENGINE ...............................3-10
Procedure for tiller control model.....3-11
WARMING UP ENGINE.........................3-13
SHIFTING ................................................3-14
Forward................................................3-14
Reverse ................................................3-14
STOPPING ENGINE ...............................3-15
TRIMMING OUTBOARD MOTOR.........3-16
Adjusting trim angle...........................3-17
CRUISING IN SHALLOW
WATER....................................................3-19
TILTING UP/DOWN ...............................3-21
Procedure for tilting up ......................3-22
Procedure for tilting down.................3-22
CRUISING IN OTHER CONDITIONS.....3-23
Cruising in salt water..........................3-23
Cruising in turbid water .....................3-23
GB
To Next Page
Loading...
