Yamaha AVENTAGE RX-A670 User Manual

Enjoying audio using Bluetooth® speakers/
headphones
Follow the procedure below to establish a Bluetooth connection between Bluetooth
speakers/headphones and the unit.
1
Use the input selection keys on the remote control to select an
input source.
Select an input source other than Bluetooth.
2
Press SETUP.
3
Use the cursor keys to select “Bluetooth” and press ENTER.
4
Use the cursor keys to set “Bluetooth” to “On”, and then set
“Transmitter” to “On” in the same way.
5
Use the cursor keys to select “Device Search” to search the
Bluetooth devices.
The list of available Bluetooth devices is displayed.
6
Select the Bluetooth speakers/headphones to be connected with
the unit and press ENTER.
When the connection process finishes, audio played back on the unit will
be reproduced from the Bluetooth speakers/headphones.
Note
▪ If the desired Bluetooth device is not displayed on the list, set the Bluetooth device to the pairing
mode and then select “
Device Search”.
▪
To terminate the Bluetooth connection, perform the disconnect operation on the Bluetooth
speakers/headphones.
En
60

Yamaha AVENTAGE RX-A670 Specifications

General

Channels	7.2
HDMI Pass-through	Yes
HDMI eARC	Yes
Surround Sound	Yes
Phono Input	Yes
Subwoofer Output	2
Zone 2 Audio Output	Yes
YPAO Calibration	Yes
Wi-Fi	Yes
Bluetooth	Yes
AirPlay	Yes
MusicCast	Yes
Spotify Connect	Yes
HDMI Inputs	6
HDMI Input/Output	6 in / 1 out
HDMI Outputs	1
Audio Formats Supported	Dolby Atmos, DTS:X
Digital Audio Input/Output: Optical	2
Digital Audio Input/Output: Coaxial	2
Analog Audio Input/Output	4 in / 1 out
Dimensions (W x H x D)	435 x 151 x 329 mm
Video Features	4K Ultra HD, Dolby Vision