Yamaha BANSHEE - Handlebar Switches

EBU00053
Handlebar switches
1. Light switch “LIGHTS”
2. Engine stop switch “ENG. STOP”
EBU11580
Engine stop switch “ENG. STOP”
Make sure that the engine stop switch is in the
“RUN” position before starting the engine. The
engine stop switch controls ignition and can
be used at all times to stop the engine, espe-
cially in an emergency. The engine will not
start or run when the engine stop switch is
turned to “OFF”.
EBU13741
Light switch “LIGHTS”
Set the switch to the “LO” position to turn on
the low beam and the taillight.
Set the switch to the “HI” position to turn on
the high beam and the taillight.
Set the switch to the “OFF” position to turn off
all the lights.
NOTE:
The headlights and the taillight can be turned
on only when the engine is started.
4-2
q
w
5FK-9-17-01 3/3/04 10:13 PM Page 22