Need help?Do you have a question about the Yamaha CS-3 0 and is the answer not in the manual?
General| Brand | Yamaha |
|---|---|
| Model | CS-3 0 |
| Category | Synthesizer |
| Language | English |
Instructions for removing the synthesizer panel by unscrewing and lifting.
Steps to remove the keyboard after the panel is detached.
Setting up VCO1 and WSC1 for correct frequency outputs.
Adjusting pulse width and pulse width modulation circuits.
Setting up VCO2 and WSC2 for correct frequency outputs.
Adjusting pulse width and pulse width modulation circuits.
Adjusting the frequency modulation circuit for VCO2.
Adjusting the VCF1 circuit for correct cutoff frequency and resonance.
Adjusting the VCF2 circuit for correct cutoff frequency and resonance.
Adjusting VCA1 for correct voltage control and output levels.
Adjusting VCA2 for correct voltage control and output levels.
Setting up and testing the ring modulator circuit.
Adjusting Envelope Generator 1 parameters.
Adjusting Envelope Generator 2 parameters.
Adjusting Envelope Generator 3 parameters.
To Next Page
