35
■ POLY/MONO
This determines whether the voice in each Layer is played
monophonically (only one note at a time) or polyphonically (up to
32 notes at a time).
Generally, Polyphonic mode is selected to generate multiple
sounds at one time. There are cases, however, where it is more
effective to select Monophonic mode, such as when using a
bass sound, brass sound, or an analog synthesizer sound.
Settings:
POLY (Polyphonic), MONO (Monophonic)
You can play up to 32 notes at a time. However, the
number of notes may be reduced or truncated if you use voices which
consist of two elements and/or play a rather complicated song which
uses too many notes.
PERFORMANCE MULTI
DEMO
STORE UTILITY
BANK PROGRAM
SYSTEM MIDI ASSIGN
VOLUME PAN REV
SEND
CHO
SEND
EFFECT
VARI
SEND
CUTOFF
FILTER
REZ
POLY/
MONO
LAYER
■ Tips About Performance Mode
• In Performance Mode, you can use a Performance (voice)
and 12 Parts (Part 5~16) for Multi. Though the receive
channels are set in the factory as shown in the illustration,
you can change the receive channels using RCV CH (Receive
Channel) in Utility Mode.
• If a channel is selected for both Performance and one of
the Parts, the two will be played simultaneously, producing
two sounds at one time. Check the settings for the receive
channels when you play the Performance and get an
unintentional sound besides the Performance.
• In Performance Mode, you cannot modify the Multi settings
on the panel except for the receive channel setting. Use an
external MIDI device such as sequencer to modify the Multi
settings.
• You can play only one Performance at one time. It is not
possible to use the Performances as Parts for the Multi or to
configure the Layers using the Performances.
Performance
Layer 1
Layer 2
Layer 3
Layer 4
Ch. 1
Multi
Part 5
Part 6
Part 7
Ch. 5
Ch. 6
Ch. 7
Part 14
Part 15
Part 16
Ch. 14
Ch. 15
Ch. 16
MIDI Receive Channels set
at the factory
To Next Page
Loading...
Need help?
General
