To Next PageTo Next PageWhy is the sound distorted on my Yamaha Speaker System?
Sound distortion in your Yamaha Speaker System can occur if the input volume is too high. If the [MIC/LINE] switch is set to [MIC], try setting it to the [LINE] position, even if you lower the volume fully and the sound is still distorted. Additionally, if the [LIMIT] indicator is on, turn the [LEVEL] knob to lower the output level until the [LIMIT] indicator only lights occasionally.
What to do if my Yamaha Speaker System power suddenly went off?
If the power to your Yamaha Speaker System suddenly goes off, it's likely that the protection system was activated. To resolve this, turn off the power, allow the amplifier to cool down, and then turn it on again.
How to stop Yamaha DBR from howling (feedback)?
If your Yamaha Speaker System is producing a howling sound (feedback), it could be because a microphone is directed toward the speaker, or the sound is amplified too much. Try aiming the speaker away from the area where the microphone picks up sound. Also, lower the volume of input device and locate the microphone more closely to the sound source.
What to do if sound is interrupted suddenly on my Yamaha DBR?
If the sound from your Yamaha Speaker System is suddenly interrupted, the protection circuit may have activated, muting the output. Allow the amplifier to cool down. If the unit doesn’t automatically reset, turn the power off, and then on again.
General| Type | Powered Speaker |
|---|---|
| Amplifier Class | Class-D |
| Inputs | XLR, 1/4" TRS, RCA |
| Outputs | XLR |
| Enclosure Material | Plastic |
| Mounting Options | Pole mount |
| Coverage angle | 90° x 60° |
| I/O Connectors | XLR, 1/4" TRS, RCA |
| Woofer Size | 12" |
| Tweeter Size | 1.4" |
| Protection | Overcurrent protection |
Proprietary sound-processing for high-resolution audio.
Optimizes frequency response for different applications.
DSP-controlled protection for reliability in challenging environments.
Details input jacks (CH1/CH2), output switch, and output jack.
Covers LEVEL knobs, MIC/LINE, D-CONTOUR, HPF switches, and indicators.
Information on AC IN, power switch, vent, screw holes, and pole socket.
Covers single DBR, dual DBRs with subwoofers, and floor monitor setups.
Addresses symptoms like no power, no sound, and distortion with fixes.
Installation using BWS251-300, BWS251-400 wall, and BCS251 ceiling brackets.
Covers BBS251 baton bracket and securing screws/eye bolts.
Guidance on correct angles and safety for eye bolt suspension.
Detailed specifications for DBR15, DBR12, and DBR10 models.
Instructions for proper disposal of used electronic products.
Covers electrical shock, fire, damage, and immediate safety actions.
Precautions for safe operation, placement, and upkeep.
Advice on safe connections and avoiding environmental harm.
Notices on unit modification, cable use, and interference.
Explains UK plug wiring based on wire colors for safety.
Lists contact details for regional sales and support.
