Why Yamaha Outboard Motor gauge operates unstably?
If the gauge operates unstably, it could be because a resistor is not connected to the ending hubs. Connect the gray 6-pin cap to the ending multi-hubs.
How to fix Yamaha E40JWH Outboard Motor trim gauge showing incorrect position?
If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sender could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sender.
Why Yamaha E40JWH Speedometer or Comb. Speedometer & Fuel mgt gauge shows incorrect fuel level?
If the speedometer or combination speedometer & fuel management gauge shows an incorrect fuel level, the fuel sensor selection is likely wrong. Set up the fuel sensor to the correct resistance.
What to do if Yamaha E40JWH gauge shows “----”?
If the gauge displays '----', it indicates that the digital signal is not being received. Check that the couplers are securely connected and replace any damaged bus wires or hubs.
What causes Yamaha E40JWH fuel management gauge to show incorrect remaining fuel?
If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting may be wrong (specifically for SQR Fuel mgt Gauge). Fill the tank with fuel, and set the correct fuel tank capacity.
How to fix Yamaha E40JWH tachometer showing incorrect engine RPM?
If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong (especially for multi-applications). To correct this, push the 'SET' button for 10 seconds to default the engine number, then memorize each engine number again.
Why Yamaha E40JWH illumination does not light?
If the illumination does not light, it could be due to a lack of electrical power or a damaged gauge. You should try replacing the fuse, connecting the couplers securely, replacing the damaged wire or hub, or replacing the gauge.
What to do if Yamaha E40JWH fuel management gauge shows incorrect fuel consumption?
If the fuel management gauge shows incorrect fuel consumption, the engine recognition might be wrong (especially for multi-applications). To fix this, default the engine number and turn the key switch on in order from the portside engine to re-memorize each engine number.
What does it mean when my Yamaha E40JWH gauge shows “----”?
General| Brand | Yamaha |
|---|---|
| Model | E40JWH |
| Category | Outboard Motor |
| Language | English |
Step-by-step guide for safely removing the outboard motor from its crate.
Guidance on proper motor mounting for optimal performance and reliability.
Guidance on choosing the right propeller based on engine speed and boat load.
Lists propeller applications for various models and horsepower ratings.
Describes throttle control systems and compatible models for remote controls.
Describes the features and functions of the multi-function tiller handle.
Provides wiring diagrams for the multi-function tiller handle in US models.
Applications and models for analog tachometers, essential for outboard performance monitoring.
Applications and models for digital tachometers, including trim and oil indicators.
Types and applications of speedometers, including digital and analog models.
Functions and applications of the fuel management gauge for fuel monitoring.
Wiring diagrams for digital network gauges in various engine configurations.
Table of common issues, causes, measures, and notes for gauge system.
To Next Page
