– 34 –
6. Remove the screws 1, and then remove the cover
2.
7. Drain the fuel from the carburetor by loosening the
drain screw 3 on the carburetor float chamber.
8. Turn the engine switch to “OFF”.
9. Turn the fuel cock knob to “OFF”.
10. Tighten the drain screw 3.
11. Install the cover and tighten the screws.
12. Turn the fuel tank cap air vent knob to “OFF”.
3
7DK-071
13. Tighten further if any screws, bolts and nuts are
loose.
14. Store the generator in a dry, well-ventilated place,
with the cover placed over it.
7DK-9-11_a 11.3.21 15:19 Page 34
To Next Page
Loading...
