What to do if Yamaha F15CEH fuel management gauge shows incorrect fuel consumption?
If the fuel management gauge shows incorrect fuel consumption, the engine recognition might be wrong (especially for multi-applications). To fix this, default the engine number and turn the key switch on in order from the portside engine to re-memorize each engine number.
What to do if the Yamaha Outboard Motor gauge display does not wake up?
If the gauge display doesn't wake up, it could be due to a lack of electrical power or a damaged gauge. Try these steps: replace the fuse, securely connect the couplers, replace any damaged wires or hubs, or, if necessary, replace the gauge itself.
Why Yamaha F15CEH Outboard Motor illumination does not light?
If the illumination does not light, it could be due to a lack of electrical power or a damaged gauge. You should try replacing the fuse, connecting the couplers securely, replacing the damaged wire or hub, or replacing the gauge.
How to fix Yamaha F15CEH tachometer showing incorrect engine RPM?
If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong (especially for multi-applications). To correct this, push the 'SET' button for 10 seconds to default the engine number, then memorize each engine number again.
What causes Yamaha F15CEH Outboard Motor fuel management gauge to show incorrect remaining fuel?
If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting may be wrong (specifically for SQR Fuel mgt Gauge). Fill the tank with fuel, and set the correct fuel tank capacity.
What to do if Yamaha Outboard Motor gauge shows “----”?
If the gauge displays '----', it indicates that the digital signal is not being received. Check that the couplers are securely connected and replace any damaged bus wires or hubs.
Why Yamaha Outboard Motor Speedometer or Comb. Speedometer & Fuel mgt gauge shows incorrect fuel level?
If the speedometer or combination speedometer & fuel management gauge shows an incorrect fuel level, the fuel sensor selection is likely wrong. Set up the fuel sensor to the correct resistance.
How to fix Yamaha F15CEH Outboard Motor trim gauge showing incorrect position?
If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sender could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sender.
Why Yamaha F15CEH Outboard Motor gauge operates unstably?
If the gauge operates unstably, it could be because a resistor is not connected to the ending hubs. Connect the gray 6-pin cap to the ending multi-hubs.
What causes Yamaha F15CEH gauge response to be poor or down?
If the gauge response is poor or down, a market obtainable unit connected to the system may have failed, or the signal volume has exceeded 50% of the capacity. Try replacing the unit or removing the heavy signal output unit.
General precautions to observe at all times for safe operation and maintenance of the outboard motor.
Instructions on attaching the engine shut-off cord to prevent the boat from running away if the operator falls.
Precautions for gasoline spills, skin contact, and ingestion, emphasizing immediate medical attention.
Detailed instructions and warnings for safe refueling of gasoline, including fire and explosion hazards.
Instructions on attaching the engine shut-off cord clip to the switch to stop the engine if the operator falls.
Step-by-step instructions for mounting the outboard motor on the boat, emphasizing safety and proper procedure.
Warning about checking all items before operation and inspecting/repairing any malfunctions.
Warning about mooring the boat and checking for swimmers before starting the engine.
Warning about swimmers before shifting and caution for warming up engine before shifting into gear.
Warnings about hot oil and secure mounting, and cautions about overfilling or underfilling engine oil.
Section describing basic checks and remedies for common problems related to fuel, compression, or ignition systems.
Troubleshooting steps for when the starter does not operate, checking battery, connections, fuses, and components.
General| Max Output | 15 hp |
|---|---|
| Gear Ratio | 2.08 (27/13) |
| Starting System | Electric |
| Fuel Induction System | Carburetor |
| Alternator Output at W.O.T. | 12V - 10A |
| Displacement | 362 cc |
| Bore x Stroke | 63.0 mm x 58.1 mm |
| Full Throttle Operating Range | 5, 000 - 6, 000 rpm |
| Shaft Length | 381 mm (15 in) |
| Engine Type | 4-Stroke SOHC |
To Next Page
