Operation
41
IP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
3. Open the throttle grip as shown in the il-
lustration.
IP:
●
If the throttle is opened too much, the en-
gine speed rises rapidly, causing the out-
board motor to swivel toward the starboard
side.
●
Do not repeat opening and closing of the
throttle grip as this cause the spark plug to
wet with fuel and prevent from the engine
to start.
4. Hold this throttle grip position by tighten-
ing the throttle friction adjuster.
5. Pull the manual starter handle slowly un-
til you feel resistance. Then give a
strong pull straight out to crank and start
the engine. Repeat if necessary.
6. After the engine starts, slowly return the
manual starter handle to its original po-
sition before releasing it.
7. Loosen the throttle friction adjuster and
return the throttle to the fully closed po-
sition.
WARNING! Loosen the throttle
ZMU05533
N
ZMU02026
ZMU06640
ZMU06608
ZMU05536
To Next Page
Loading...
