Trouble Recovery
85
8. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
rotor and wind the rope 1 or 2 turn(s)
around the flywheel clockwise.
9. Pull the rope slowly until resistance is
felt. Give a strong pull straight out to
crank and start the engine. If the engine
does not start on the first try, repeat the
procedure.
IP:
●
If the engine does not start on the first try,
repeat the procedure. If the engine fails to
start after 4 or 5 tries, open the throttle a
small amount (between 1/8 and 1/4) and
try again. Also if the engine is warm and
fails to start, open the throttle a same
amount and try to start the engine again. If
the engine still fails to start, see page 39.
●
Slowly return the throttle grip to the fully
closed position so that the engine does not
stall.
EMU33501
Treatment of submerged motor
If the outboard motor is submerged, immedi-
ately take it to a Yamaha dealer. Otherwise
some corrosion may begin almost immedi-
ately.
NOTICE:
Do not attempt to run the
outboard motor until it has been com-
pletely inspected.
[ECM00401]
ZMU05533
N
ZMU02026
ON STARTOFF
ZMU01906
ZMU05622
To Next Page
Loading...
