Trouble Recovery
101
6. Drain the water in the filter cup by soak-
ing it up with a rag.
7. Firmly screw the filter cup onto the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when screwing the filter cup onto the
filter housing.
[ECM01970]
8. Connect the water detection switch cou-
pler securely until a click is heard.
9. Fasten the water detection switch lead
with the plastic tie.
10. Install the top cowling.
11. Start the engine and make sure that the
water separator-alert indicator remains
off. Have a Yamaha dealer inspect the
outboard motor after returning to port.
F70
1. Stop the engine.
2. Remove the top cowling.
3. Remove the cover.
4. Remove the holder.
1. Filter cup
2. Water detection switch lead
1. Water detection switch coupler
1. Plastic tie
6C1-9-3B-1E0.book 101 ページ ２０１２年１１月１９日 月曜日 午前１０時３５分
To Next Page
Loading...
