Operation
64
3. Place the throttle grip in the “ ”
(start) position. After the engine starts,
return the throttle to the fully closed po-
sition.
4. Turn the main switch to “ ” (start),
and hold it for a maximum of 5 seconds.
5. Immediately after the engine starts, re-
lease the main switch and allow it to re-
turn to “ ” (on). NOTICE: Never turn
the main switch to “ ” (start)
while the engine is running. Do not
keep the starter motor turning for
more than 5 seconds. If the starter
motor is turned continuously for
more than 5 seconds, the battery will
be quickly discharged, thus making it
impossible to start the engine. The
starter can also be damaged. If the
engine will not start after 5 seconds
of cranking, return the main switch to
“ ” (on), wait 10 seconds, then
crank the engine again.
[ECM00192]
When the engine is cold, it needs to be
warmed up. For further information, see
page 66.
If the engine is warm and fails to start,
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 95.
EMU27664
Electric start and remote control models
EWM01840
Failure to attached engine shut-off cord
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-
off cord to a secure place on your cloth-
ing, or your arm or leg while operating.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1. Place the remote control lever in neutral.
6C1-9-3B-1E0.book 64 ページ ２０１２年１１月１９日 月曜日 午前１０時３５分
To Next Page
Loading...
