Operation
53
● If the engine does not start, place the throt-
tle grip in the “ ” (warm engine)
position and try again.
● It is not necessary to use the choke when
starting a warm engine.
5. After the engine starts, slowly return the
manual starter handle to its original posi-
tion before releasing it.
6. Slowly return the throttle grip to the fully
closed position.
EMU34924
Electric start models (tiller control)
EWM01840
● Failure to attached engine shut-off cord
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-off
cord to a secure place on your clothing,
or your arm or leg while operating. Do
not attach the cord to clothing that could
tear loose. Do not route the cord where
it could become entangled, preventing it
from functioning.
● Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power, the
boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
Starting procedure (cold engine)
1. Place the gear shift lever in neutral.
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
U6DR30E0.book Page 53 Friday, November 30, 2012 4:27 PM
To Next Page
Loading...
