Yamaha F9.9 - Tilting Down (Power and Manual Tilt Models)

Operation
62
2. After stopping the engine, disconnect the
fuel hose from the fuel joint on the out-
board motor by turning it counterclock-
wise.
3. Install the fuel joint cap on the outboard
motor.
4. Disconnect the fuel hose from the fuel
joint on the fuel tank by turning it counter-
clockwise.
5. Tighten the air vent screw by turning it
clockwise.
6. When using the fuel tank on a boat, close
the fuel valve.
TIP:
Check the boat’s manual for the position of
the fuel valve.
7. Remove the key if the boat will be left un-
attended.
TIP:
The engine can also be stopped by pulling the
cord and removing the clip from the engine
shut-off switch, then turning the main switch
to “ ” (off).
1. Fuel joint
2. Fuel hose
1. Fuel joint cap
2
1
ZMU07458
1
ZMU07459
1. Fuel joint
2. Fuel hose
1. Air vent screw
2
1
ZMU07443
1
ZMU07444
U6DR30E0.book Page 62 Friday, November 30, 2012 4:27 PM