E
4-10
EMU19351
MAINTENANCE CHART
Frequency of maintenance operations may be adjusted according to the operating condi-
tions, but the following table gives general guidelines. Refer to the sections in this chapter
for explanations of each owner-specific action.
The mark (●) indicates the check-ups which you may carry out yourself.
The mark (1) indicates work to be carried out by your Yamaha dealer.
NOTE:
When operating in salt water, turbid or muddy water, the engine should be flushed with
clean water after each use.
10 hours 50 hours 100 hours 200 hours
(1 month) (3 months) (6 months) (1 year)
Cleaning / adjustment /
replacement
Greasing points Greasing ●
Fuel system Inspection ●●●
Fuel filter (disposable) Inspection / replacement ●/1 ●/1 ●/1
Fuel tank (Yamaha
portable tank)
Idling speed (carburetor
models)
Inspection / adjustment ●/1 ●/1
Anode(s) Inspection / replacement ●/1 ●/1
1
Cooling water passages Cleaning ●●
Propeller and cotter pin Inspection / replacement ●●
Timing belt Inspection / replacement
11
Battery Inspection / charging ●/1
Throttle link / throttle cable
/ throttle pick-up timing
Shift link / shift cable Inspection / adjustment
1
Power trim and tilt unit Inspection
1
Engine oil Inspection / change ●●
Oil filter (built into oil pan)
Inspection / cleaning /
change
Valve clearance (OHC,
OHV)
Inspection / adjustment
11
Cowling clamp Inspection ●
6G8-9-1M-4 4/4/03 11:45 AM Page 11