Yamaha FJR 2005 User Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-33
6
EAU24310
Replacing the license plate
light bulb
1. Remove the license plate light unit
by removing the screws.
2. Remove the socket (together with
the bulb) by pulling it out.
3. Remove the defective bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the license plate light unit by
installing the screws.
EAU27011
Replacing an auxiliary light
bulb
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb burns
out, replace it as follows.
1. Remove panel D (if replacing the
left auxiliary light bulb) or panel C
(if replacing the right auxiliary light
bulb). (See page 6-5.)
2. Remove the auxiliary light socket
(together with the bulb) by turning
the socket counterclockwise.
3. Remove the defective bulb by pull-
ing it out.
1. Screw
2. License plate light unit
1. License plate light bulb
1. Auxiliary light bulb socket
U3P620E0.book Page 33 Tuesday, January 24, 2006 10:47 AM
ProCarManuals.com

Yamaha FJR 2005 Specifications

General

Compression Ratio	10.8:1
Fuel System	Fuel injection
Transmission	5-speed
Final Drive	Shaft
Front Tire	120/70-ZR17
Rear Tire	180/55-ZR17
Wheelbase	60.8 in
Ignition	Digital TCI
Rear Suspension	Single shock; adjustable preload and rebound damping
Rear Brakes	282mm disc
Seat Height	31.7 in
Fuel Capacity	6.6 gal
Engine Type	1298cc, liquid-cooled, inline 4-cylinder, DOHC, 16 valves