What to do if my Yamaha FL200FET gauge display does not wake up?
If the gauge display doesn't wake up, it could be due to a lack of electrical power or a damaged gauge. Try these steps: replace the fuse, securely connect the couplers, replace any damaged wires or hubs, or replace the gauge itself.
Why is the illumination not lighting on my Yamaha FL200FET gauge?
If the illumination isn't lighting, it could be because of a power issue or a damaged gauge. You should try replacing the fuse, ensuring the couplers are securely connected, replacing any damaged wires or hubs, or replacing the gauge.
Why does my Yamaha FL200FET fuel management gauge show incorrect fuel consumption?
If the fuel management gauge shows incorrect fuel consumption, the engine recognition may be wrong. To resolve this, default the engine number. Then, turn the key switch on in order from the portside engine to re-memorize each engine number.
How to fix a Yamaha FL200FET Outboard Motor tachometer that shows incorrect engine RPM?
If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong. Push the SET button for 10 seconds to default the engine number, and then memorize each engine number again.
What to do if my Yamaha FL200FET speedometer shows the incorrect fuel level?
If the speedometer shows an incorrect fuel level, the fuel sensor selection is likely wrong. You should set up the fuel sensor to the correct resistance.
What does it mean when my Yamaha Outboard Motor gauge shows “----”?
If the gauge shows “----”, it indicates that the digital signal is not being received. Make sure the couplers are securely connected and replace any damaged bus wires or hubs.
Why does my Yamaha FL200FET fuel management gauge show incorrect remaining fuel?
If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting is probably wrong. Fill the tank with fuel, and then set the correct fuel tank capacity.
Why does my Yamaha FL200FET trim gauge show the incorrect position?
If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sensor could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sensor.
Why is my Yamaha FL200FET gauge operating unstably?
If the gauge operates unstably, it's likely that the resistor isn't connected to the ending hubs. Connect the gray 6-pin cap to the ending multi-hubs to resolve this.
Why is the Yamaha Outboard Motor gauge response poor?
If the gauge response is poor, a market obtainable unit connected to the system may have failed, or the signal volume has exceeded 50% of the capacity. Replace the faulty unit or remove the heavy signal output unit.
General| Brand | Yamaha |
|---|---|
| Model | FL200FET |
| Category | Outboard Motor |
| Language | English |
Step-by-step instructions for safely removing the outboard motor from its shipping crate.
Guidelines for correctly positioning the outboard motor on the boat transom.
Detailed overall dimension items and measurements for outboard motors.
Guidance on selecting the appropriate propeller based on load and performance.
Catalog of standard propellers and their applications for 2014 models.
Description of throttle control systems and applicable models for remote controls.
Guidance on selecting and routing remote control cables for proper length.
Overview of features and electrical functions of the 6x4 tiller handle.
Procedures for mounting gauges, including angle and clearance requirements.
Functions, applications, and kit contents for fuel management gauges.
Wiring diagrams for single, twin, triple, and quad engine applications.
Procedure for initial setup of digital network gauges for multi-engine installations.
Table of common symptoms, causes, measures, and notes for troubleshooting gauges.
Guidance on selecting batteries based on model, capacity, and charging voltage.
Wiring examples for single and multi-engine battery installations with isolators.
Checklist for pre-delivery inspection to ensure customer satisfaction.
To Next Page
