Yamaha FX High Output WaveRunner 2006 User Manual

2-21
E
EJU21583
Selecting the normal mode/
low-RPM mode
The normal mode and low-RPM mode
can only be selected when the engine is
stopped in the unlock mode. Press the
unlock button for more than 4 seconds to
select the normal mode or low-RPM mode.
Normal mode
If the beeper sounds twice, the normal
mode is activated.
The watercraft can be ridden normally.
Low-RPM mode
If the beeper sounds three times, the
low-RPM mode is activated and the
“L-MODE” indicator light 1 comes on.
Maximum engine speed (r/min) in the
low-RPM mode is limited to approximately
80% of the maximum engine speed in the
normal mode.
N
O
TE:
@
●
If neither the start switch nor the remote
control transmitter is operated within
25 seconds after the unlock button is
pressed to select the unlock mode, the
multifunction meter display and the
“L-MODE” indicator light will go off. If this
occurs, press the lock button briefly to
select the lock mode, press the unlock
button briefly to select the unlock mode,
and then press the unlock button again for
more than 4 seconds to select the normal
mode or low-RPM mode.
●
While the engine is running, input from
the remote control transmitter is not
received.
@
CAUTION:
@
If the remote control transmitter does not
operate when its buttons are pressed,
the battery may be low. Have a Yamaha
dealer replace the battery.
@
E_F1X-10.book Page 21 Friday, August 5, 2005 10:34 AM

Yamaha FX High Output WaveRunner 2006 Specifications

General

Brand	Yamaha
Model	FX High Output WaveRunner 2006
Category	Boat
Language	English