Yamaha MT-01 - Wheels, Tires, and Pedals Checks; Lights, Signals, and Switches Checks

PRE-OPERATION CHECKS
4-3
4
Drive chain
• Check chain slack.
• Adjust if necessary.
• Check chain condition.
• Lubricate if necessary.
6-18, 6-20
Wheels and tires
• Check for damage.
• Check tire condition and tread depth.
• Check air pressure.
• Correct if necessary.
6-13, 6-15
Brake and shift pedals
• Make sure that operation is smooth.
• Lubricate pedal pivoting points if necessary.
6-21
Brake and clutch levers
• Make sure that operation is smooth.
• Lubricate lever pivoting points if necessary.
6-22
Sidestand
• Make sure that operation is smooth.
• Lubricate pivot if necessary.
6-22
Chassis fasteners
• Make sure that all nuts, bolts and screws are properly tightened.
• Tighten if necessary.
—
Instruments, lights, signals
and switches
• Check operation.
• Correct if necessary.
—
Sidestand switch
• Check operation of ignition circuit cut-off system.
• If system is defective, have Yamaha dealer check vehicle.
3-20
ITEM CHECKS PAGE
U5YUE3E0.book Page 3 Thursday, September 20, 2007 3:03 PM