To Next Page
R
Rachel LoveAug 7, 2025
What to do if the oil level is low in my Yamaha MZ360?
- Aapril69Aug 8, 2025
If the engine oil level is low in your Yamaha Engine, simply add more engine oil.
What to do if the oil level is low in my Yamaha MZ360?
If the engine oil level is low in your Yamaha Engine, simply add more engine oil.
What to do if Yamaha MZ360 Engine has a faulty battery or starter motor?
If you suspect a faulty battery or starter motor in your Yamaha Engine, it is recommended you consult a Yamaha dealer.
What to do if my Yamaha Outboard Motor engine does not start?
If your Yamaha Outboard Motor engine won't start, several factors could be at play. Begin by ensuring sufficient oil and fuel levels, replenishing if needed. If the fuel is old, replace it. Confirm the fuel cock lever is set to the “ON” position. Inspect the fuel tank and hose for blockages, cleaning or replacing as necessary. Also, check the spark plug; it may need re-gapping or replacement. If the ignition spark gap is okay, the ignition system is likely functioning correctly. Other potential solutions include replacing the ignition coil or spark plug cap, cleaning components, addressing carbon deposits in the combustion chamber by decarbonizing it, adjusting valve clearance, resurfacing or replacing the valve face and valve seat, correcting any issues, or reboring or replacing parts if ...
Schedule for regular maintenance and lubrication tasks.
Procedures for inspecting the engine, including compression pressure.
Method for measuring engine compression pressure.
Steps for adjusting the governor linkage and settings.
Exploded views and parts for these major engine assemblies.
Inspection of crankshaft sprocket, runout, and pin diameter.
Method for measuring connecting rod big end oil clearance.
Wiring diagrams for various engine configurations.
Method for measuring and checking the ignition spark gap.
Troubleshooting guide for when the engine fails to start.
Table of recommended tightening torques for various fasteners.
Schedule for regular maintenance and lubrication tasks.
Procedures for inspecting the engine, including compression pressure.
Method for measuring engine compression pressure.
Steps for adjusting the governor linkage and settings.
Exploded views and parts for these major engine assemblies.
Inspection of crankshaft sprocket, runout, and pin diameter.
Method for measuring connecting rod big end oil clearance.
Wiring diagrams for various engine configurations.
Method for measuring and checking the ignition spark gap.
Troubleshooting guide for when the engine fails to start.
Table of recommended tightening torques for various fasteners.
General
