Quick Guide
PSR-3000/1500 Owner’s Manual
34
Adjusting the Tempo or Setting the Time Signature of the Metronome
Sound
■ Adjusting the Metronome Tempo
1 Press the TEMPO [–]/[+] button to call up the pop-up tempo setting display.
2 Press the TEMPO [–]/[+] buttons to set the tempo.
Pressing and holding either button lets you continuously increase or decrease the value.
You can also use the [DATA ENTRY] dial to adjust the value. To reset the tempo, press the TEMPO [–]/[+] but-
tons simultaneously.
n About the Tempo display
The number in the display indicates how many quarter-note beats there are in one minute. The range is between 5 and
500. The higher the value, the faster the tempo.
3 Press the [EXIT] button to close the Tempo display.
■ Determine the Metronome Time Signature and Other Settings
1 Call up the operation display:
[FUNCTION] → [I] UTILITY → TAB [
√
] CONFIG 1 → [B] 2 METORONOME
2 Set the parameters by pressing the [2
ππ
ππ
††
††
]–[7
ππ
ππ
††
††
]
buttons.
VOLUME Determines the level of the metronome
sound.
SOUND Determines which sound is used for the met-
ronome.
Bell Off............... Conventional metronome
sound, with no bell.
Bell On............... Conventional metronome
sound, with bell.
TIME
SIGNATURE
Determines the time signature of the metro-
nome sound.
To Next Page
Loading...
Need help?
General
