English
11
RM-TT Installation Manual
Be sure to install this unit using the methods described in this manual.
Without mounting onto the table
1. Plug the LAN cable into the Dante/PoE port.
Route through the cable slot as shown below.
NOTICE
: Use STP (Shielded Twisted Pair) cable to prevent electromagnetic interference.
: When disconnecting the LAN cable from the Dante/PoE port, wait at least
five seconds before reconnecting the cable. Otherwise, damage or malfunctions
may result.
2. Place this unit on the table.
This completes the installation.
INSTALLING ON A TABLE
To Next Page
Loading...
