What to do if Yamaha Music Equipment displays a “firmware mismatch” error?
If your Yamaha Music Equipment displays a 'firmware mismatch' error, ensure that each device has a compatible firmware version.
Why does Yamaha Music Equipment audio cut out or distort?
Audio cutouts or distortion in your Yamaha Music Equipment can occur if the MADI input frequency is incorrect. If MADI or WCLK IN is selected as the word clock source, try changing it to DANTE. Note that doing so will result in the clocks for the Dante network and the unit not being synced. Also, ensure that the unit is set as the clock master for the Dante network.
What to do if Yamaha Music Equipment mixer does not recognize the RMio64-D?
If your Yamaha Music Equipment mixer isn't recognizing the RMio64-D, the Dante [Unit ID] might be set to a different ID than other Yamaha Dante-compatible devices on the same network. Also, check if the network switch is working properly by turning it on again. Finally, a defective cable could be the cause, so try replacing it.
Overview of the RMio64-D's digital interface capabilities, including Dante and MADI support.
Guidelines for safely installing the unit in an EIA standard rack, focusing on ventilation and heat management.
Information on updating the unit's firmware to improve operations, add functions, or correct issues.
Detailed description of the controls and indicators located on the front panel of the RMio64-D unit.
Description of connectors and controls found on the rear panel, including power, Dante, and MADI connections.
Instructions and diagrams for connecting the RMio64-D to a Dante network using Daisy Chain and Star configurations.
Guidance on connecting MADI-compatible devices using 75Ω coaxial cables.
Steps for connecting the AC power cord to the unit and a power supply socket safely.
General| Channels | 64 |
|---|---|
| Audio Interfaces | MADI, Dante |
| Sample Rates | 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz |
| AD/DA Conversion | 24-bit/96kHz |
| Form Factor | 1U Rackmount |
| Network Protocol | Dante |
| Compatibility | Dante, MADI |
| MADI | Yes |
| Dante | Yes |
| Word Clock | Yes |
| Connector Type | RJ45 |
To Next Page
