Why is there no sound from one speaker on my Yamaha RX-E100 Stereo Receiver?
If you're experiencing sound from only one speaker on your Yamaha Stereo Receiver, check for loose speaker connections and ensure they are properly connected.
What to do if no sound from external unit connected to Yamaha Stereo Receiver?
If you're not getting sound from an external unit connected to your Yamaha Stereo Receiver, or if playback won't start, ensure that the cords are connected properly. If the issue continues, the cords may be defective. Also, verify that you've selected the correct input source.
What to do if Yamaha RX-E100 remote control does not work?
If your Yamaha Stereo Receiver's remote control isn't working, first, replace the batteries with new ones. If that doesn't solve the problem, make sure you are within 6 meters and a 60-degree radius of the unit. Also, check if direct sunlight or strong lighting is interfering with the remote control sensor; if so, try changing the position of the unit.
How to fix Yamaha RX-E100 Stereo Receiver that won't turn on?
If your Yamaha Stereo Receiver isn't turning on when you press the power switch, ensure the AC power cord is securely connected to the outlet and the receiver.
How to eliminate buzzing during AM broadcasts on Yamaha RX-E100?
Buzzing or static during AM broadcasts on your Yamaha Stereo Receiver can be caused by interference from sources like lightning, fluorescent lights, electric motors, or thermostats. Grounding the AM loop antenna may lessen the problem. Also, move the receiver away from TVs or microprocessors.
How to reduce static in FM broadcasts on Yamaha RX-E100 Stereo Receiver?
Excessive static in FM broadcasts on your Yamaha Stereo Receiver can be due to interference. Try positioning the FM antenna as high and as far away from nearby roads as possible, and connect it using a coaxial cable.
Why does my Yamaha Stereo Receiver sound “hums”?
If your Yamaha Stereo Receiver is producing a humming sound, ensure the audio cables are securely connected. If the problem persists, the cables may be defective.
Why is there noise during stereo broadcasts on my Yamaha RX-E100 Stereo Receiver?
If noise increases during stereo broadcasts on your Yamaha Stereo Receiver, check the antenna connection. If possible, install a multi-element type FM antenna.
Why are stereo broadcasts noisy on my Yamaha RX-E100 Stereo Receiver?
If stereo broadcasts are noisy and the STEREO indicator blinks on and off on your Yamaha Stereo Receiver, it indicates insufficient antenna input. Install an antenna appropriate for the electric field strength of your area.
How to improve AM broadcast sensitivity on Yamaha RX-E100?
If the AM broadcast sensitivity is poor on your Yamaha Stereo Receiver, properly connect the AM loop antenna. You can also try changing the orientation of the AM loop antenna or installing an external AM loop antenna.
General| Type | Stereo Receiver |
|---|---|
| Number of Channels | 2 |
| Tuning range | FM, AM |
| Frequency Response | 20 Hz to 20 kHz |
| Input Sensitivity/Impedance | 200 mV/47k ohms (CD) |
| Output | Speaker |
| Speaker load impedance | 6 ohms |
| Speaker Impedance | 6 ohms |
| Audio Output | Stereo |
| Input Sensitivity | 200mV (line) |
To Next Page
