Firmware Update Procedure for RX-V2067
Page.1 of 6
February, 2011
Subject: RX-V2067 Firmware Update ver. 3.15
Yamaha is pleased to offer this firmware update to ensure the best possible
performance for your Yamaha RX-V2067 AV Receiver.
This firmware improves contents playback stability
The following pages contain the firmware update instructions for RX-V2067. You can
easily update the latest firmware through the Internet or by using a USB thumb drive.
In order to properly execute the update, read all instructions carefully.
CHECK THE UNIT’S FIRMWARE VERSION PRIOR TO THIS UPDATE
On the remote control, press the ON SCREEN button.
Select “Information” > “System”. Your current firmware version is displayed on TV.
If your firmware version is 3.15 or higher, the AV receiver is already up-to-date.
If not, choose from the following 2 methods to update to the latest firmware.
9 Click here if your AV receiver is connected to the Internet.
9 Click here if your AV receiver is NOT connected to the Internet.
(In this case, a USB thumb drive is required)
In case of error, see the troubleshooting section on the last page for recovery
method.
< IMPORTANT NOTICE >
Do not attempt to update your Yamaha receiver using any other data file except those provided
directly from the Yamaha website or through your network connection.
Follow the instructions carefully and do not attempt any other procedures not specified in the
instructions provided by Yamaha.
Improperly updated products may cause improper operation, and any parts or service required
to restore proper operation will not be covered under the Yamaha Limited Warranty.
To Next Page
Need help?
General
