47
ADVANCED
OPERATION
English
Using the test tone
Use the test tone to set speaker levels so that the volume
from each speaker is identical when heard from your
listening position.
1 Press TEST.
The unit will output a test tone.
2 Press u / d repeatedly to select a speaker
to adjust.
Each time you press d, the unit will cycle through
the speakers in the following order:
TEST LEFT (
front
L)→TEST CENTER (center)→
TEST RIGHT (
front
R)→TEST SUR.R (surround
R)→TEST SUR.L (surround L)→TEST
SUBWOOFER (subwoofer)→.....
(Press u to cycle the speakers in the reverse order.)
3 Press –/+ to adjust the speaker output level.
4 Press TEST when you have completed your
adjustment.
The test tone halts.
Notes
•You cannot enter test mode if headphones are connected to the
PHONES jack. Remove the headphones from the PHONES
jack.
•You cannot adjust speaker volumes if the “SOUND 1
SPEAKER SET” parameter on the set menu is set to NONE.
•You cannot adjust the subwoofer level if the “1D BASS”
parameter in “SOUND 1 SPEAKER SET” in the set menu is
set to FRNT.
• If you select “BASIC 1 SETUP” in the set menu and then
select “SET”, speaker levels change in response to any
changes you make in “BASIC 1 SETUP”.
y
•Depending on the source the unit is reproducing, the speaker
levels set with the test tone may not be to your liking. If this is
the case, adjust the speaker levels while listening to the
source.
SETTING THE SPEAKER LEVELS
Adjusting the speaker levels
during playback
You can adjust the output level of each speaker while
listening to sound playback.
1 Press LEVEL repeatedly to select the
speaker you want to adjust.
The unit cycles through the speakers in the following
order each time you press LEVEL:
FRONT L→CENTER→FRONT R→
SUR R. (surround R)→SUR L. (surround L)→
SWFR (subwoofer)→.....
y
•Pressing LEVEL once opens the level display. Press u / d at
this time to select a speaker.
2 Press –/+ to adjust the speaker output level.
•The center and surround speakers can be adjusted
by a maximum of –10dB ~ +10dB.
•The front speakers and subwoofer can be adjusted
by a maximum of –20dB ~ 0dB.
Notes
•You cannot adjust speaker levels if the “SOUND 1 SPEAKER
SET” parameter in the set menu is set to NONE.
•You cannot adjust the subwoofer level if the “1D BASS”
parameter in “SOUND 1 SPEAKER SET” in the set menu is
set to FRNT.
• If you use LEVEL to adjust speaker levels, the speaker levels
you previously set with the test tone will also change.
• If you select “BASIC 1 SETUP” in the set menu and then
select “SET”, speaker levels change in response to any
changes you make in ”BASIC 1 SETUP”.
PROG PROG
LEVEL
SET MENU
MUTE
VOLUME
2
1
TEST
PROG PROG
STEREO
LEVEL
SET MENU
q
/DTS 6.1/5.1
NIGHT SLEEP
MUTE
VOLUME
VOLUME
To Next Page
General
