To Next PageTo Next PageWhat to do if my Yamaha Stereo Receiver has no sound or picture?
First, ensure that the output cords are correctly connected. If the issue continues, the cords may be defective and need replacement. Also, verify that you've selected the appropriate input selector corresponding to your input source.
What to do if my Yamaha Stereo Receiver suddenly goes silent?
This may happen because the protection circuit has been activated due to a short circuit or excessive power. If all speakers go silent, check the speaker cords, turn the unit off, and then on again. After that, reduce the volume and try again. If only the front speakers are affected, check their cords and reduce the volume.
Why is there no sound from the center speaker on my Yamaha Stereo Receiver?
First, check that the sound output level of the center speaker isn't set to 0. Adjust it using the CENTER level control. Also, make sure the center mode is set to NORMAL or WIDE, not PHANTOM. Finally, ensure you've selected an appropriate sound field program.
Why is there no sound from the rear speakers on my Yamaha Stereo Receiver?
First, check if the sound output level of the rear speakers is set to 0. If so, increase it using the REAR level control. Also, if you're playing a monaural sound source in DOLBY PRO LOGIC or ENHANCED mode, try selecting a different program that's more suitable for monaural audio.
How to fix Yamaha Stereo Receiver FM stereo noisy reception?
Noisy FM stereo reception can occur when the transmitter is too far away or the antenna input is poor. Check the antenna connections. If needed, try using a multiple element FM antenna to improve reception.
What to do if my Yamaha Stereo Receiver only outputs sound from one speaker?
Check the BALANCE control and adjust it to the appropriate position. Also, verify that the speaker cords are properly connected. If the problem persists, the cords might be defective.
What to do if my Yamaha Stereo Receiver won't turn on?
Make sure the power cord is fully and firmly plugged into the outlet.
Why is my Yamaha Stereo Receiver sound distorted?
The distortion may be due to multipath interference. Try adjusting the antenna placement to minimize this interference.
Why is my Yamaha Stereo Receiver volume low when playing a record?
If you are using a turntable with an MC cartridge, connect the player to the unit through the MC head amplifier.
How to fix Yamaha Stereo Receiver sound hum?
Ensure that the audio plugs are firmly connected. If the humming persists, the cords may be defective.
General| Audio Channels | 5.1 |
|---|---|
| Amplifier | Discrete |
| Frequency Response | 10 Hz - 100 kHz |
| Total Harmonic Distortion | 0.06% |
| Total Harmonic Distortion (0.06% THD) | 0.06% |
| Input Sensitivity | 200 mV |
| Signal-to-Noise Ratio | 100 dB |
| HDMI Inputs | 4 |
| HDMI Output | 1 |
| 3D Support | Yes |
| Audio Return Channel (ARC) | Yes |
| Dolby Digital | Yes |
| DTS | Yes |
| FM/AM Tuner | Yes |
| Dimensions | 17.1 x 6.3 x 15.4 in |
| Dimensions (W x H x D) | 435 x 151 x 315 mm |
| Weight | 22.5 lbs |
| Power Output (6 ohms) | 100 W |
| Input Sensitivity/Impedance | 200mV/47k ohms |
| HDMI Version | 1.4 |
Details FCC compliance, warns against modifications, and advises on interference mitigation.
Provides crucial safety and operational advice for using the unit, covering installation and handling.
Explains how DSP recreates acoustic environments from live performances.
Describes the Dolby Pro Logic Surround Decoder for realistic movie theater sound.
Details the enhanced mode for a more immersive surround sound experience.
Explains 5-speaker and 4-speaker configurations and their settings.
Provides recommendations for placing front, rear, and center speakers for best sound.
Details how to connect the unit to other audio/video components correctly.
Step-by-step instructions for connecting speaker wires to the terminals.
Guides on adjusting speaker output levels for optimal sound balance using a test tone.
Explains how to use automatic search to find radio stations.
Details how to manually tune in radio stations by adjusting frequency.
Step-by-step guide on how to store desired radio stations using preset buttons.
Instructions on how to select and play a previously stored radio station.
Details how to adjust the delay time for sound effects using the remote control.
