To Next PageTo Next PageWhy does the picture not appear on my Yamaha RX-V520RDS?
If the picture does not appear when using your Yamaha Receiver, ensure that the output and input for the video are connected to the same types of video jacks. Use the same type of jack (composites, S-VIDEOs, or components) for both the input and output.
Why can I hear a humming sound from my Yamaha RX-V520RDS Receiver?
If you hear a humming sound from your Yamaha Receiver, make sure the audio plugs are firmly connected. If the problem continues, the cables may be defective and need to be replaced.
Why is FM stereo reception noisy on my Yamaha Receiver?
Noisy FM stereo reception on your Yamaha Receiver can occur if the transmitter is too far away or the antenna input is poor. Check the antenna connections and consider using a high-quality directional FM antenna.
General| Type | AV Receiver |
|---|---|
| Channels | 5.1 |
| Power Output | 100 W |
| Power Output (8 ohms) | 100 W |
| Frequency Response | 10 Hz - 100 kHz |
| Total Harmonic Distortion | 0.06% |
| Input Sensitivity | 200 mV |
| Input Sensitivity (MM) | 2.5 mV |
| Input Sensitivity (line) | 200 mV |
| Signal-to-Noise Ratio | 100 dB |
| Signal to Noise Ratio (line) | 100 dB |
| Weight | 10.5kg |
| Tuner Section | FM/AM |
| Speaker load impedance | 8 ohms |
| Digital inputs | 2 optical, 1 coaxial |
| Video Connections | composite |
| Dimensions | 435 x 151 x 363 mm |
| FM Sensitivity | 1.0 µV |
| Surround Sound | Dolby Pro Logic |
Critical safety instructions for operating the unit.
Details on the unit's 5-channel power output.
Detailed description of the unit's front panel buttons and display.
How to connect digital and analog audio components.
Guide for connecting video components like DVD players and VCRs.
Detailed instructions for wiring speakers to the unit.
Using the test tone to balance speaker output levels.
How to choose and manage input signals for playback.
Adjusting speaker modes (MAIN, CENTER, REAR).
Adjusting BASS OUT, MAIN LVL, HP TONE CTRL, I/O ASSIGN.
Configuring INPUT MODE, DOLBY D. SET, DTS SET, D-RANGE.
Setting delay for DSP programs based on speaker distance.
Adjusting levels for center, rear, and subwoofer.
Programming the remote for other brands.
Common issues and their solutions.
Troubleshooting radio reception and remote control.
