Yamaha SUPER TENERE XT1200Z User Manual

INSTRUMENT AND CONTROL FUNCTIONS
3-33
3
EAU49475
Adjusting the rider seat height
The rider seat height can be adjusted
to one of two positions to suit the rid-
er’s preference.
The rider seat height was adjusted to
the higher position at delivery.
To change the rider seat height to
the low position
1. Remove the rider seat. (See page
3-32.)
2. Remove the rider seat height posi-
tion adjuster by pulling it out.
3. Install the rider seat height posi-
tion adjuster so that the match
mark is aligned with the “L” mark
as shown.
4. Insert the projection on the rear of
the rider seat into seat holder A as
shown.
To change the rider seat height to
the high position
1. Remove the rider seat. (See page
3-32.)
2. Remove the rider seat height posi-
tion adjuster by pulling it out.
1. Low position
2. High position
1 2
1. Rider seat height position adjuster
1. Rider seat height position adjuster
2. “L” mark
3. Match mark
1
3
2
1
1. Projection
2. Seat holder A (for low position)
1
2
U2BSE0E0.book Page 33 Tuesday, September 17, 2013 8:55 AM

Yamaha SUPER TENERE XT1200Z Specifications

General

Displacement	1199 cc
Bore x Stroke	98.0 mm x 79.5 mm
Compression Ratio	11.0:1
Fuel System	Fuel Injection
Ignition	TCI: Transistor Controlled Ignition
Starter	Electric
Final Drive	Shaft
Rear Suspension	Monoshock, adjustable preload and rebound damping
Fuel Capacity	23 liters
Seat Height	845 mm
Wet Weight	261 kg
Width	980 mm
Engine Type	Liquid-cooled, DOHC, 4-valve
Transmission	6-speed
Front Suspension	43mm telescopic fork, adjustable preload and rebound damping
Front Brakes	Dual 310mm discs, ABS
Rear Brakes	282mm disc, ABS
Front Tire	110/80R19
Rear Tire	150/70R17