3 - 14
INSP
ADJ
4. To stiffen the spring preload, install the
circlip 1 into the groove a. To soften the
spring preload, install the circlip into the
groove b.
OTE:
Do not spread the circlip too much.
5. Install:
● Spring guide 1
OTE:
While compressing the spring, install the
spring guide.
Standard installation position:
Groove b
6. Install:
● Rear shock absorber
Refer to “SWINGARM” section in the
CHAPTER 5.
EC36Q000
TIRE PRESSURE CHECK
1. Measure:
● Tire pressure
Out of specification → Adjust.
OTE:
● Check the tire while it is cold.
● Loose bead stoppers allow the tire to slip off
its position on the rim when the tire pressure
is low.
● A tilted tire valve stem indicates that the tire
slips off its position on the rim.
● If the tire valve stem is found tilted, the tire is
considered to be slipping off its position. Cor-
rect the tire position.
Standard tire pressure:
100 kPa (1.00 kgf/cm
2
, 14.5 psi)
TIRE PRESSURE CHECK
To Next Page
Loading...
